WIFI Controlled Relay Switch Kit - Internet Of Things (IOT)
WIFI Remote Switch Controller Kit- Internet Of Things (IOT
This WIFI Remote Switch Controller connects directly to your WIFI access point so you can control up to 8 switches independently from PrivateEyePi, or another application. It is fully assembled and requires no soldering. Connect it to power and it will advertise itself as a wireless access point. Configure it through a web browser using its easy to use config application. Once configured it will connect to your WIFI network which will give it access to the internet and the PrivateEyePi server.
Easy to configure web interface. No programming or soldering skills required. You do not need the internet to configure the device. Connect to it directly from any WIFI device (e.g. PC, phone tablet…)
Control up to 8 relay switches through the 16 pin GPIO header
You can add temperature sensors to it (soldering required DS18B20 for only temperature or DHT22 for temperature and humidity - 2 GPIO pins are used if temperature sensor is added). Alternatively purchase a WI01 or WI02 and connect relay switches to their of those devices. Refer WI01 or WI02 for temperature sensor features.
Powered either by USB Mini cable (4.5V DC to 7V DC input) or battery connection (2.5V to 3.5V) via the 2 pin battery connection plug
Fully programmable using the Arduino or LUA development environments
The device supports dual WIFI mode allowing it to be WIFI access point and a WIFI client at the same time. A WIFI access point advertises itself through an SSID and can be connected to via any device or computer that has WIFI. .
Required, but not included:
Mini USB cable and power supply (older cell phones used mini USB, so you may already have one in the bottom of a drawer)
5V to 7V power supply. Any USB power supply will work.